Guilin Feiyu Electronic Technology Co.,Ltd
Guilin Feiyu Electronic Technology Co.,Ltd http://www.feiyudz.cn Tel:0773-5815749
13
Way 3
FY-3ZT
Debugging instructions
The debugging of the FY3-ZT can be started once you finished installed FY3-ZT and the
GCS software of the ground control station.
Ⅰ.
Communication Debugging
1.
Turn on your computer, and running the GCS ground station software.
2.
Turn on the adapter board power supply, the adapter plate light will flash slowly, Select correct
communications port connections from GCS software. Baud Rate 19200.
3.
Turn on the RC remote control.
4.
Turn on the autopilot power.
5.
If everything correctly, you will see the received telemetry data through the ground station
software .when the pressure altitude is about 0 meters (Auto-Initialization initial boot height is
0 meters), control remote controller rudder, you will see the rudder output through the rudder
display table. That means the ground station has already connected with the autopilot.
When FY605 in data radio transmission status, the red light up and in receiving status, the
green light up .if you find transmission of the data radio caused the rudder beating for each time,
please placed the data radio away from the rudder.
Ⅱ
.Servo control direction setting and debugging
1. FY3-ZT own mixing function, all the remote controller are set to
the control mode for the normal layout aircraft. Please choose
the correct mixing mode in “rudder control mode” to change the
layout of the aircraft. Please reference to the below table:
