Installing a Fixed Station (Continued)
Setting Station Parameters with the Operating Panel
•
Station type
•
Frequency pair
•
Selective address code
•
Physical end limits antenna
•
Auto search scan limits antenna
•
Reference azimuth
•
Auto search
•
Anti-icing
•
Auto recovery
•
Configuration protection
•
Gyro compensation
•
IP address
The quickest way to set these parameters is by going through the
configuration procedure
.
1. Switch the station on by switching the 230 VAC power to the antenna unit on.
Note:
The ON/OFF switch on the operating panel is not functioning!
2. Wait about 60 seconds for the station to start up.
3. Press Menu; the MAIN MENU MOB, MAIN MENU FIX or MAIN MENU BCN appears.
4. Press 5 (CONFIG). The following page appears:
If the second line reads MOB or BCN:
5. Press Enter; the cursor (<) starts blinking.
6. Press the
▲
or
▼
key until it reads FIX.
7. Press Enter to acknowledge.
8. Press Next; the following page appears:
Where *:**** **** can have the following values:
If the frequency pair showing is not the desired frequency pair:
9. Press Enter; the cursor (<) starts blinking.
10. Press the
▲
or
▼
key until the desired frequency pair shows.
11. Press Enter to acknowledge.
12. Press Next; the following page appears:
13. Press Enter; the cursor (<) starts blinking.
14. Using the numerical keys 0-9, enter the desired address code (0-63), i.e. the same address
code the Mobile Station is set for and press Enter to confirm.
15. Press Next; the following page appears:
Note:
If the antenna can rotate by 360°, this step can be skipped by pressing Next.
21
