21. Press Enter if you wish to change the IP address; the cursor (<) starts blinking.
22. Using the numerical keys 0-9, enter the required IP address and press Enter to confirm.
23. Press Next; the following page appears:
24. Press Menu; the Main Menu BCN appears and the beacon goes into operation.
As soon as the Beacon picks up signal from a Mobile Station set at the same frequency pair and
address code the antenna of the Mobile Station will lock onto the Beacon and distance to the
Beacon will be available at the Mobile Station.
If the parameter CONF.PRTCTED was set to OFF, Beacon parameters can be modified remotely
from the Control PC connected to the Mobile Station using the Artemis Service Interface.
If no other Beacon parameters need to be set or changed using the operating panel, the operating
panel may now be disconnected.
!
Screw the cap of the operating panel socket back on after disconnecting the operating
panel.
Installing a Beacon (Continued)
26
