GÜDE Expert Power Control 8041 Series, Руководство пользователя

Страница: 71 / 118

71
Expert Power Control 8041/8045 © 2022 GUDE Systems GmbH
Specifications
"{EVT_SYSLOG=0,EVT_SNMP=1,EVT_EMAIL=2,EVT_SMS=3,EVT_GSMEMAIL=4,EVT_BEEPER=5}"
To set EVT_SYSLOG and EVT_EMAIL in a command, you can use the following syn-
tax:
>extsensor 1 2 0 events type set "EVT_SYSLOG,EVT_EMAIL"
OK.
or numeric
>extsensor 1 2 0 events type set "0,2"
OK.
Additionally you can set all values with "ALLSET" or encode any bit pattern as hexa-
decimal with a syntax like "#7f1a".
Return Values
If a command is unknown or a parameter is incorrect, the output "ERR." is given at the
beginning of the line, followed by a description of the fault. Successful instructions
without special return value will be acknowledged by "OK.". All other return values are
output within a single line. There are of two exceptions:
1. Some configuration changes, that affect TCP / IP and UDP, need a restart to be ap-
plied. These parameters are output on two lines. In the first line the current value is
shown, on the second row the value after a restart. In the "Cmd Overview" table this
is marked with "Note 2".
2. Other configurations (such as the assigned IPv6 addresses) have several values that
can change dynamically. This is marked with "Note 3" in the "Cmd Overview" table.
Numerical Returns
For parameters that support constants, these constants are output as return values. To
better deal with scripting languages, it may be easier to work only with numerical re-
turns. The command "
vt100 numeric set ON
" enables that only numerical values
appear.
Comments
If you use a tool to send an entire file of commands via Telnet, it is helpful, if you can
place comments in there. Beginning with the comment character "#", the remaining con-
tents of a line is ignored.
Telnet
If the configuration "Raw Mode" is turned off, it is tried to negotiate the Telnet configura-
tion between client and server using IAC commands. If this fails, the editing functions are
not active, and the "Activate echo" option determines whether the characters sent to the
Telnet server will be returned. Normally the client begins with the IAC negotiation. If this
is not the case with the client, the device configuration "Active negotiation" should be
turned on.