２１
of 23 Ver 2.0 File No.: S1200020
A Professional GSM Alarm System designer and manufacturer!
GSM SMS Controller Alarm &GSM House Alarm System&
GSM Telemetry Units & GSM GPRS Logging System
9) More information will be available of the S120, we will not inform you again after we upgraded, please check
with your dealers.
12. Maintenance
1) If the Control Unit works, while the remote key and other detectors fail, please check and change the battery.
2) If the remote key works, but the Control Unit fails to send SMS texts, switch the power of Control Unit off and
switch it on after one minute . Test this system after another minute, or check the settings are correct and the
GSM Signals are strong enough.
3) If the Control Unit can run and detectors work, but cannot send SMS texts, please change SIM Card to check
it.
4) If the problem cannot be solved, please contact the distributor or manufacturer.
5) The battery is not in the warranty according to its lifetime limited.
13. Warranty
1) This system is warranted to be free of defects in material and workmanship for one year from the date of
purchase.
2) This warranty does not extend to any defect, malfunction or failure caused by abuse or misuse by the
Operating Instructions. In no event shall the manufacturer be liable for any alarm system altered by
purchasers.
14.Trouble Shooting Guide
PROBLEM
CAUSE
POSSIBLE SOLUTION
GSM Module
initialization
failed
1) Backup battery with low
voltage;GSM Module
connection loose in
transportation;
2)
GSM Signal is too
weak.
1) Please contact the AC Power;
2) Please help to take the panel to a mobile phone repairmen store, and then
ask the engineer to check the GSM Module socket and the GSM Module
connection;
3) Please change another position to install the alarm panel.
Automatically
Restart
1) Backup battery with low voltage.
1) Please help to contact the AC Power.
Wireless
Detector
transmission
short
1) Wireless detector with low
voltage;
2) Wireless detector used PT2262
IC, and incorrect Value;
3) Haven’t pull out wireless
antenna;
4) Electromagnetic interference;
5) The wireless receiver in the
panel with problem.
1) Please replace the battery of the wireless detector, usually once /year;
2) Please correct the resistor value to 3.3M Ohm of the PT2262 Wireless
detector;
3) Please pull out the wireless detector antenna;
4) Please install the wireless detectors or alarm panel away the electric
equipments;
5) Please contact your distributors or manufacturer to replace it.
False Alarm
1) PIR Motion detector installation
incorrect;
2) Used 24H zones or SOS Zones
or Watchdog zone.
3) NC/NO/EOL is incorrect.
1) Please see the PIR Motion detector installation user manual carefully;
2) Please check if any detector assigned to these special zones and made
incorrect activated;
3) Please check the detector NC/NO type and NC/NO/EOL Correctly..
