１２
of 23 Ver 2.0 File No.: S1200020
A Professional GSM Alarm System designer and manufacturer!
GSM SMS Controller Alarm &GSM House Alarm System&
GSM Telemetry Units & GSM GPRS Logging System
the calling, then can not wiretap the system site, if somebody answers the calling, then can create two-way voice
communication.
3)
If Switch off the siren, then all alarm raised will not drive the siren, if switch on the siren, then when the system alarm will drive
the siren for 2 minutes except the SOS help caused. Default is Switch on.
4)
If setup the Self-Checking, the system will periodically send “GSM Alarm System in good working condition” to the first SMS Alert
number. This is very useful for long time use the system. Default is 0. Means will not report the system condition.
5)
If enable the power failure alert function, the system will send SMS “AC Power Failed 30Min.” to the first SMS Alert numbers
after the AC power failure 30minutes, if the power is recovery then will send SMS “AC Power is OK.”. Default is disabled.
6)
When Backup battery lower than 10.8V, will send SMS “Backup Battery with Low Voltage” to the first SMS Alert Number.
7)
There’s no delay for Stay Mode.
6.2.2.4 Advanced Setting
Notice:
1) The watchdog is special for elder or child or
on-duty personnel
, in the period (Starting time point to Ending time point) if this
detector hasn’t been triggered, the system will alarm. This is very useful to monitor the elder or child goes out the bedroom or
enters the kitchen to eat something. Or monitor the on-duty personnel in the polling period have gone to on-site inspection.
2) If enable the RCO alert function, then when use any remote key which has been registered to the system to arm or disarm or
For example:
In China, the country code is
0086
, please note, do not write
+86
.
The user cell phone number is
13511111111
and has been assigned as a SMS Alert number, the simcard number in the panel is
13512345678
.
Problem 1: Alarm but the user hasn’t received the SMS Alert.
Solution: Please plus the country code while you setup the 13511111111 as SMS Alert number, means setup
008613511111111
or
8613511111111
to instead of the
13511111111
.
Problem 2: The user number can receive the SMS Alert message from alarm panel, but the alarm panel can not receive the
commands from the user number.
Solution: Please add country code to the simcard number in the alarm panel. Means send sms commands to
008613512345678
to instead of
13512345678
.
Solution 3: When you use cell phone dial another one, what number it will be displayed then you can set the displayed number as
dial numbers; when you use cell phone send SMS to another cell phone, what number it will be displayed then you can set the
displayed number as SMS Alert number, just use the 00 to replace the “+”.
1.Edit Timer
2. Watchdog Timer
3. RCO Alert
4. GSM Jammer Alert
5. Modify Password
6. Default Set
---To setup the starting time to arm and the Ending time to disarm.
---To setup the starting and ending time to work.
---To setup the remote key operation report function.
---To setup the GSM Jammer Alert function.
---Modify the system password.
---
Restore the system settings to factory defaults.
