CHAPTER 8 OPERATION INTRODUCTION
46
8-7-2. OUT (OUTPUT MODE)
It’s used to adjust V set value while the output is ON. When the DC power is selected to DIRECT mode, the output
voltage value will be changed either higher or lower by turning the Encoder. When the DC power is selected to
ENTER mode, the output voltage value will be only changed by pressing the ENTER key.
(3) DIRECT mode: Displayed as
(4) ENTER mode: ENTER key must be pressed. Displayed as
8-7-3. P.ON (POWER ON MODE)
When restarting the DC power /recovering mains supply, the output status is:
(3) LAST: The output status will be sustained as the previous one that is before turning off the DC power or mains
supply is interrupted. Displayed as
(If the output status is ON before power off the DC power, it will
remain output ON when restarting the DC power)
(4) OFF: The output status will be always off when restart the DC power. Displayed as
8-7-4. R.uPT (Output Voltage RAMP Up Time)
Ramp-up time can be set from 00.0 ~ 99.9s. The time setting will affect the slope of the output voltage.
8-7-5. Output Voltage RAMP Down Time (R.dNT)
Ramp-down time can be set from 00.0 ~ 99.9s. This function will be disabled if it is set at 0s. The time setting will
affect the slope of the output voltage.
