GSi PNEG-2309, Инструкция по установке и эксплуатации

Страница: 49 / 58

7
Troubleshooting
Problem: Mixer Unable to Pull Load
Possible Solutions:
1. Check all wiring for loose connections, low voltage, or undersize wiring.
2. Clean machinery. Build-up on tub and agitator must be scraped loose to re-new mixing efficiency
and reduce power consumption.
3. Mixer is being loaded too full or being loaded with ingredients too heavy for applied horsepower.
4. Amount of liquid being added is too high.
5. Improper lubrication. Check all bearings and make sure they are greased properly according to
manufacturer’s recommendations.
CAUTION
Do not over-grease bearings, seal damage will occur.
6. Check the compression of the packing seals. Over tension will cause excessive friction on the main
shaft.
7. Mixer agitator running too close to mixer tub. Agitator may need to be adjusted with shims under the
main bearings.
8. Mixer agitator running too fast. Refer to Mixer Specifications, page 19 for proper shaft speed.
9. Belt drive slippage. Belts must be properly tensioned.
Problem: Gear Reducer Excessively Noisy
Possible Solutions:
1. Oil level not properly maintained. All gear boxes are shipped without oil. Gear reducers should be
filled at the time of installation in accordance with the manufacturer’s recommendations.
2. Drain and refill oil in the gear reducer seasonally.
3. Motor coupling is not properly aligned to input shaft on reducer.
Problem: Mixer Agitator Rubbing Tub
Possible Solutions:
1. Agitator bearings loose on base. Tighten bearings down to bearing shelf.
2. Steel blocks positioning agitator bearing worked loose, allowing agitator to rub tub sides.
3. Set collars on agitator bearings are loose allowing agitator to thrust against tub ends. Re-align
agitator and tighten set collars.
PNEG-2309 Horizontal Fertilizer Mixer 49