GSi PNEG-2309, Инструкция по установке и эксплуатации

Страница: 33 / 58

Chapter 4: Mixer Assembly
8. After installing the second bushing, set the position of the reducer drive relative to the outside
surface of the end wall of the mixer.
Figure 4-10 Setting the reducer position
9. Alternately and evenly tighten the screws in the bushing nearest the equipment to the recommended
torque given in the Table 4-3, page 33 . Repeat the same for the outer bushing.
Table 4-3 Recommended torque for bushing hardware
Mixer Reducer Size Fastener Size
Torque (lbs.-ft.)
4-Ton TA8407H 1/2"-13 77-67
8-Ton TA10507H 5/8"-11 86-75
10.Fill the gear reducer with the recommended lubricant. Refer to Table 4-4, page 33 .
CAUTION
Unit is shipped without oil. Add proper amount of recommended lubricant
before operating. Failure to observe this precaution can result in damage to the
equipment. Refer to the DODGE Instructions manual supplied with the reducer
for all Dodge equipment.
Table 4-4 Oil volume for reducer
Mixer Reducer Size
Volume of Oil to Fill Reducer to Oil Level Plug*
(1 quart = 32 fluid ounces = 0.94646 liters)
Quart Liter
4-Ton TA8407H 11.7 11.1
8-Ton TA10507H 27.6 26.1
* Oil quantity is approximate. Service with lubricant until oil runs out of oil level hole.
* Below 15 RPM output speed, oil level must be adjusted to reach the highest oil level plug. If there is
a change in reducer position, either more or less oil may be required. Consult Mechanical Power
Transmission Support, Greenville, SC.
PNEG-2309 Horizontal Fertilizer Mixer 33