GSi PNEG-2309, Инструкция по установке и эксплуатации

Страница: 56 / 58

Chapter 8: Maintenance
Bearings
1. All bearings must be inspected and lubricated regularly. Please follow the manufacturer’s
specifications and schedules. Do not over lubricate the bearings since this could damage the
bearing seals.
2. Bearings should be checked periodically for excessive heat or wear. Bearings that are damaged will
overheat or have a grinding noise while the machine is in operation. If either occur, stop the machine
immediately. A damaged bearing could seize, causing serious damage to the shaft. Call your local
bearing representative or dealer for replacement or service.
3. Periodically check the set screws for proper tension. This will ensure that the shaft is not turning
about the inside race of the bearing.
Gear Reducer
Gear reducers are shipped without lubricant to comply with ICC Regulations. Be sure to examine
the oil level in the gear reducer prior to start-up. Refer to the manual supplied with the gear reducer
for the recommended level and lubricant type.
Drive V-Belts
The V-belt drive should be checked at least once a month for proper tension and belt condition.
Shafts Seals
• The shaft seals are a stuffing box style seal with a removable cover on it. The box is filled with an
Oakum or Jute packing.
• The packing is then wet down with oil or gear lubricate. If the seal begins to leak, additional oil can
be added or the packing may need to be removed and replaced with new material.
56 PNEG-2309 Horizontal Fertilizer Mixer