GSi PNEG-2309, Инструкция по установке и эксплуатации

Страница: 37 / 58

Chapter 4: Mixer Assembly
3. Install two 1" hex nuts (24) onto a 1" x 9" threaded rod (10), one at approximately 5" and another
one at 2" from the end of the rod for a starting position. Repeat for the remaining threaded rods (10).
4. Place the 1" x 9" threaded rods (10) through the holes in the base plate (39) and secure in place
using 1" hex nuts (24) on the bottom, so the base plate (39) is between the two nuts (24).
5. Install the mount plate (40) onto the 1" x 9" threaded rods (10) and secure with 1" hex nuts (24).
Figure 4-15 Installing the motor mount plate with threaded studs
10
1" x 9" threaded rod (BG-0099)
39
Base plate
24
1" hex nut (S-240)
40
Motor mount plate
6. Align the motor (41) with the correct holes in the motor mount plate (40) and install using
5/8" x 2-1/2" HHCS bolts (7), 5/8" flat washers (16) and 5/8" hex nuts (22).
NOTE: Use 1" hex nuts to adjust the height of the motor (41).
Figure 4-16 Installing the motor to the motor mount plate
7
5/8" x 2-1/2" HHCS bolt (S-20223)
40
Motor mount plate
16
5/8" flat washer (S-7084)
41 Motor
22
5/8" hex nut (S-7363)
PNEG-2309 Horizontal Fertilizer Mixer 37