Grundig GRT-K1104A, Руководство пользователя

Страница: 90 / 138

12. Network Settings
12.1. Configuring the General Settings
The network settings must be properly configured before you operate the NVR/DVR over the network.
Steps:
1. Enter the Network Settings interface: Menu> Con fi guration> Network
2. Select the “General” tab.
3. In the “General Settings” interface, you can con fi gure the following settings: Working Mode, NIC Type, IPv4
Address, IPv4 Gateway, MTU and DNS Server. If the DHCP server is available, you can click the checkbox of
“DHCP” to automatically obtain an IP address and other network settings from that server.
4. After having con fi gured the general settings, click the “Apply” button to save the settings.
12.2. Configuring the Advanced Settings
12.2.1. Configuring the PPPoE Settings
Your NVR/DVR also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Steps:
1. Enter the “Network Settings” interface: Menu> Con fi guration> Network
2. Select the “PPPoE” tab to enter the PPPoE Settings interface.
3. Check the “Enable PPPoE” checkbox to enable this feature.
4. Enter the “User Name”, and “Password” for PPPoE access.
NOTE: The User Name and Password should be assigned by your ISP.
5. Click the “Apply” button to save and exit the interface.
6. After successfully fi nishing the settings, the system asks you to reboot the device to enable the new settings,
and the PPPoE dial-up will be automatically connected after the reboot. You can go to Menu> Maintenance>
System Info> Network interface to view the status of the PPPoE connection. Please refer to Chapter “Viewing
System Information” for the PPPoE status.
12.2.2. Configuring the Extranet Access
You can choose the access to the device by DDNS through the settings on the “Extranet Access” menu.
90 English