Grundig 40VLE630BH, Руководство по обслуживанию

Страница: 25 / 180

TP CHASSIS / TELEVISION
25 September 2011
3. Select ANTENNA SETTINGS with and press OK. Menu will be displayed.
4.Select the required tabs with . Satellite : Select the desired satellite from the
list with or and press OK . Transponder: You can select a transponder
from the list, change or delete the current transponder or add a new transponder LNB
Power: Set LNB power to Off or, depending on LNB type, to 13/18V or 14/19V with
. LNB Type: Select the LNB type used in the satellite system with
and press ● (Green) to store, ● (Red) to cancel it. 22KHz: Depending on LNB type,
22KHz is selected. In universal LNB, this option is set to Automatic and cannot be
changed. DISEqC Mode: Based on the number of current satellite systems, select
Off, DiSEqC 1.0 or DiSEqC 1.1 with
B / A. Off: It is used for satellite systems with single antenna. DiSEqC 1.0: DiSEqC
1.0 switch allows for receiving from maximum 4 satellites at the same time. DiSEqC
1.1: DiSEqC 1.1 switch allows for receiving from maximum 16 satellites at the same
time. LNB selection: In this tab, use to make selections between 1/16 and
16/16 for the satellite that corresponds to the relevant DiSEqC positions.
5.2. 3D Function
5.2.1. 3D Picture Viewing
3D function is only supported at »HDMI«, »YPbPr«, »VGA«, »USB«, »DLNA«,
»DVB-T«, »DVB-C« and »DVB-S« inputs. With »HDMI«, »YPbPr« and »VGA« inputs,
3D mode is not active except resolutions at »1280x720p 50/60 Hz«, »1920x1080i 50
/60 Hz« and »1920x1080p 24 / 30, 50 / 60 Hz«. 3D experience may change
depending on the format and features of the picture (resolution, sharpness and etc)
supplied from the external input. 3D effect may degrade if you watch 3D images
under fluorescent light. In such cases, either reduce the light or turn off the lamp.
While 3D mode is active, if Manual or Automatic search menus, Program Table or
EPG menu are turned on, the channel or the source are changed, or the playback is
completed or the next file starts to play in USB or PVR modes, your TV will switch to
2D mode.
1 Open the »Select Source« menu with »AV«.
2 Select AV source that will be played 3D with »<«,
»>« or »V«, »
Λ « and confirm with » ● «.
3 Select the 3D mode with »3D« as »Side by Side«
or »Top Bottom« in accordance with the content to
be played and confirm with »
● «.
– »2D → 3D«: Changes 2D picture to 3D.
– »Side by Side«: Displays a picture next to the
other one.
– »Top Bottom«: Displays a picture below the other
one.
– »Frame Packing«: Right and left images of the
TV are displayed in turn.
Note:
Frame Packing appears in 3D menu only if a video
signal is send from an external device