Grizzly T27710, Руководство пользователя

Страница: 114 / 118

52
Reassembly
KohlerEngines.com 18 690 01 Rev. C
Install Oil Sentry
TM
Module
1. Install Oil Sentry
™
module and secure with screw.
2. Connect electrical leads for Oil Sentry
™
module.
Install Fuel Tank
1. Route fuel line across top of engine toward
carburetor while positioning fuel tank on mounting
brackets.
2. Secure with screw on inner mounting bracket.
3. Install nuts on fuel tank studs.
4. Torque fuel tank screw and nuts to 24 N·m
(212 in. lb.).
5. Position fuel line in clip at carburetor and connect
fuel line to shut-off valve on carburetor. Secure
clamp.
Install Carburetor Cover
Install outer air cleaner cover onto studs and secure with
nuts.
Install Muf fl er and Heat Shield Assembly
1. Install a new exhaust gasket with muf fl er and heat
shield assembly. Secure muf fl er and heat shield
assembly with nuts.
2. Torque nuts to 8 N·m (70.8 in. lb.).
Install Air Cleaner Base, Element, and Cover
Dual-Element
1. Install air cleaner base and secure with screws.
2. Install paper element with precleaner onto air
cleaner stud and secure with washer and wing nut (if
equipped).
3. Install air cleaner cover and secure with wing nut.
Low-Pro fi le
1. Install air cleaner base and secure with screws.
2. Install foam element (lightly oiled) into base.
3. Install cover and secure with screw.
Prepare Engine for Operation
Engine is now reassembled. Before starting or operating
engine be sure to do following:
1. Make sure all hardware is properly torqued.
2. Make sure oil drain plugs, oil
fi ll plugs, and Oil
Sentry
™
wire lead bullet connectors are tightened
securely.
3. Fill crankcase with correct oil. Refer to Maintenance
and Lubrication System for oil recommendations and
procedures.
Testing Engine
NOTE: Do not adjust maximum no-load high-idle engine
speed beyond 3950 RPM maximum.
It is recommended engine be operated on a test stand or
bench prior to installation on a piece of equipment.
1. Set engine up on a test stand. Check gas and oil
levels. Start engine and run for 5-10 minutes
between idle and midrange. Adjust low-speed idle
screw so low idle speed is set to 1800 RPM (± 150)
or application speci fi cations.
2. Adjust high-speed stop screw as necessary to
3850 + 100 RPM (typical RPM).