Model G0853 (Mfd. Since 07/18)
-61-
To position crosscut table along sliding table:
1. DISCONNECT MACHINE FROM POWER!
2. Use sliding table lock lever (see Figure 116)
to secure table in position.
3. Loosen crosscut table lock lever shown in
Figure 117.
4. Move crosscut table along sliding table to
desired position, then retighten lock lever to
secure table.
Figure 116. Location of sliding table lock lever.
Sliding Table
Lock Lever
Figure 117. Location of crosscut table lock lever.
Lock Lever
4. Loosen pivot knob.
5. Place precision ruler against a blade tooth,
as shown in
Figure 118, then adjust fence so
that 3" mark on fence scale is exactly 3" from
blade tooth.
6. Tighten pivot knob,
7. Repeat measurement in Step 5.
— If measurement is not exactly 3", repeat
Steps 2–7 until it is.
Figure 118. Example of aligning fence with
center of blade.
3" Mark
End Block
To calibrate crosscut fence:
1. DISCONNECT MACHINE FROM POWER!
2. Perform steps in Positioning Crosscut
Fence on Page 59.
3. Move crosscut table (refer to Positioning
Crosscut Table Along Sliding Table on
Page 60 for instructions) so end of fence is
aligned with center of blade (see
Figure 118).
Calibrating Crosscut Fence
To accurately use the crosscut fence scale and
ensure the fence does not contact the blade, the
distance between the end of the crosscut fence
and the blade must be properly adjusted.
