Model G0853 (Mfd. Since 07/18)
-39-
Figure 59. Cord clamps and control panel cord
attached to upper and lower guard arms and
control posts.
57. Use (7) pre-installed M6-1 x 10 button head
cap screws to attach cord clamps to upper
and lower guard arms and control posts, as
shown in
Figure 59, then route control panel
cord through clamps.
Note: There should be no strain on cord as it
enters control panel.
x 7
Cord Clamps (2 of 7)
Figure 61. Location of magnetic catches that
secure blade cover.
Magnetic Catch
(1 of 2)
The Model G0853 does not ship with a main
blade. Refer to Blade Requirements and
Blade Selection beginning on Page 50 when
purchasing the main blade.
59. Move sliding table all the way backward to
expose blade cover. Pull blade cover toward
front of machine to disengage magnetic
catches (see
Figure 61).
Blade Cover
58. Use (2) M6-1 x 20 cap screws, (2) 6mm lock
washers, (3) 6mm flat washers, and (1) M6-1
hex nut to attach L-bracket to large extension
table and middle guard arm post (see
Figure
60).
Note: Before final tightening, place a straight-
edge across cast-iron table and large exten-
sion table to ensure they are level.
Figure 60. L-bracket installed on large extension
table and middle guard arm post.
x 1
x 1
