3.3 Removing the front protection
Loosen the 4 M6 screws as per figure on the side;
remove the front protection and tighten the screws to
close.
3.4 Setting the lamp
Any time the lamp has been replaced, or after the
first installation, it may be necessary to adjust the
lamp centering in relation to the optical axis of the
projector.
Proceed with this operation as follows:
1) Remove the two hole-covering stoppers located
nearby the gauging screws (pict.2);
2) Screw or unscrew the 2 screws (pict.2) which are
linked to the lamp-holder by means of springs;
3) Continue with the adjustment until you obtain a
uniform light beam.
3.5 Mounting Position
Keep at least a distance of 0.5 m from the wall to facilitate
air circulation around the projector and lower heating.
PRO-MOTION is equipped with a bracket that allows to
position the projector either on the floor or to the ceiling.
To attach the projector to the floor, or to the ceiling, the
bottom part of the bracket and ballat are provided with a
series of holes. Wheelbases are shown in pict.3.
Caution:
The projector must never be installed upside
down (pict.4), therefore, to install it on the ceiling it is
recommended to turn the bracket to the top side of the pro-
jector (pict.5). To rotate the bracket, remove the fixing
knobs, then rotate the bracket and fit the knobs again as
per pict.5.
14
NO
YES
pict.2
pict.5
pict.4
