1.0 PACKING
Check carefully the content of the box and in case of damage contact your forwarder. The unit is
packed in two boxes which respectively contain :
Box 1
Box n°2
n°1 ballast unit for Pro-Motion 2000
N° 1 PRO-MOTION 2000 unit;
N°1 Cee 3-pole (earth)
N° 1 instructions leaflet;
N° 2 M8 knobs.
2.0 SAFETY
Disconnect the lantern from mains supply before servicing the unit or replacing the lamp.
This unit has been designed for indoor and outdoor use. Maximum ambient temperature must not
exceed 40C°.
Caution: hot lamp, wait for at least 20 minutes before replacing it.
Caution: it is strongly recommended that a safety chain or wire is attached to this projector and
secured to the main mounting framework to arrest the fall of the unit, in the unlikely event that the
primary mounting arrangement should fail.
PROTECTION DEGREE IP44 - The PRO-MOTION 1200 is dust-proofed and water jets, where-
ver coming from, will not cause damage to the unit.
3.0 INSTALLATION
3.1 Fitting the bracket
Fix the bracket and adjust the inclination of the unit,
by tightening the M8 knobs. The knobs have to be
screwed into the apposite M8 inserts.
3.2 Fitting the lamp
1) Remove the top cover by unscrewing the 2 side
screws (a pict.1); (the cover will remain attached to
the projector through a cable);
2) Remove the upper protective grid by loosening the
2 fixing screws (b pict.1);
3) Remove the lamp-covering lid by loosening the 2
fixing screws (c pict.1);
4) Fit the lamp into its lamp holder:
- do not touch the lamp with fingers or dirty towels;
- do not shake the lamp.
5) Fit firmly the lamp into the lamp holder;
6) Close the projector repeating backwards the above-
mentioned steps.
Note:
Ensure that the fans work properly.
13
pict.1
30°
45°
45°
45°
