Griven GRAPHITE MK2 2000 AD3754, Инструкция по эксплуатации

Страница: 41 / 48

English 41
Graphite MK2 2000 can operate without DMX signal (in AUTOMATIC mode) and can be set so that a single
MASTER unit will command a series of SLAVE units. This function is particularly useful when more units are desired
to execute the same programme in synchrony.
The following picture shows an example of a Master-Slave layout.
10.1 AUTOMATIC configuration
To activate the AUTOMATIC mode, press the “MENU” button up to visualize “ADR”. Through the “UP” and “DOWN”
keys select “AUT”. Press “ENTER” to confirm.
Through the “UP” and “DOWN” keys select “ACT”. Through the “UP” and “DOWN” keys select “ON” or “OFF” to
activate or deactivate the AUTOMATIC mode. Press “ENTER” to confirm.
It is possible to adjust the length of time of the scenes of the programmes.
Through the “UP” and “DOWN” keys select “TI” and press “ENTER” to confirm. Through the “UP” and “DOWN” keys
select the length of time desired (5-10-20-40 seconds) and press “ENTER” to confirm.
Now, through the “UP” and “DOWN” keys, it is possible to scroll the 8 preset programmes (P1-P8). Once positioned
onto the desired programme, press “ENTER” to confirm. By the keys “UP”and “DOWN” select “ON” or “OFF”. It is
possible to activate or disactivate the programme. Press ENTER to confirm.
Using the function "ZOO" you can set the working position of the zoom. Press "ENTER" and then pressing the "UP"
or "DOWN" to select the desired value (0-255). Press "ENTER" to confirm.
Using the function "FRS", you can activate or deactivate the frost filter. Press "ENTER" and then pressing the "UP" or
"DOWN" to select ON or OFF. Press "ENTER" to confirm.
Now the unit is in AUTOMATIC mode and the diplay will keep reading “AUT”.
To exit from the AUTOMATIC mode, press the “MENU” button, select “ACT” and press “ENTER” to confirm.
Select “OFF” to deactivate the AUTOMATIC mode. Press ENTER to confirm.
10.0 Master-Slave and Automatic function
MASTER SLAVE 1 SLAVE N
IN OUT IN OUT
SLAVE 2
IN OUT
Terminal resistor
(R=120 ƺ not included!)
Warning!
It is possible to select more programmes which will be executed in sequence.
If MASTER-SLAVE mode is being used, the fixture cannot be controlled by a DMX control device
and no other DMX control device must be present along the line!!
If on the DMX line is already working a projector in AUTOMATIC mode or a DMX control device,
the display will show "BSY" and the mode will not be activated.