38
English
8.1 Setting operating mode
By the control panel it is possible to select one of the following operating modes:
• using DMX512 signal control mode
Each fixture is controlled from DMX512 signal control.
(see chapter
9.0 DMX function
)
• MASTER-SLAVE or AUTOMATIC mode
The projector operates independently, without DMX512 signal control.
(see chapter
10.0 MASTER/SLAVE and AUTOMATIC function
)
• using COLOUR mode
The projector operates independently, without DMX512 signal control.
(see chapter
11.0 COLOUR function
)
The unit NORMALLY works in DMX mode and, on turning on, the display will read the number of DMX address (e.g. 012).
If on turning on the display will read “AUT”, it will mean that the unit is working in AUTOMATIC mode.
Disable this function to go back to the DMX mode.
If on turning on, the display will read “COL”, it will mean that the unit is working in COLOUR mode.
Disable this function to go back to the DMX mode.
8.2 Unit control panel
The display of the unit is programmed to turn off
automatically after 20 seconds of non working.
To activate it just press any key.
In the presence of the DMX signal the red led will steadily
be on while in the absence of DMX signal the led will flash.
The green led is on during:
• DMX address is setting
• menu setting
8.2.1 Reading the display and using controls
MENU
button:
By pushing the “MENU” button the display will show the main menu or you can exit from function and go back to
main menu.
By pushing the “MENU” button when is show the DMX address, you will enter in the main menu.
• address setting
ADR
• MASTER/SLAVE and AUTOMATIC mode
AUT
• COLOUR mode
COL
• Lamp management
LMP
• Utility
UTI
• Firmware release
REL
UP
and
DOWN
buttons:
By pushing the “UP” and “DOWN” buttons, values of the function which is shown in the display can be changed.
ENTER
button:
Keep the “ENTER” button pushed, until the display and the SET led flash, in order to memorize the function which
is shown on the display.
8.0 Use of the unit
made in Italy by
