34
English
D.
Warm up the tube by using a heater for heat shrink tubes
“15”
till the complete shrinkage.
The connection so obtained features an
IP67
protection rate.
If the unit which you are connecting is the last one of the DMX line, insert a 120 Ω terminal resistor connected
between DATA- and DATA+, as shown and following.
Execute stages
“A”
and
“B”
, as previously described.
C.
Connect the 120 Ω resistor
“16”
between DATA- and DATA+
and press the butt connectors by a proper tool.
D.
Heat the tube
“17”
by using a heater for heat shrink tubes
“18”
till the complete shrinkage and then press the final end of the
tube with a pincer
“19”
in order to seal the connection.
15
16
DA
TA
-
DA
TA
+
17
18
19
