GREAT PLAINS 5109, Руководство оператора

Страница: 20 / 38

07/11/2018 Table of Contents Index 566-224M
TC5109-5323 Table of Contents Index Preparation and Setup 16
Wing Adjustment (5313-5315)
Refer to Figure 10
17. Once the machine is level fore to aft, the wings may
be leveled (Models 5313-5315). Start by unfolding
the wings to a rigid position.
18. Completely extend the wing fold cylinders and check
the wings for levelness. If machine is not level, fold
wings back up and instal shims as needed to level.
 Extra shims are stored in manual pak. The extra
shims may be needed in the future if the hinge holes
or bolts begin to wear. There are two different
thickness of shims, you may use multiple shims to
level wings.
19. Remove the two
3

8
x 1
1

2
bolts and either add
more shims to raise wings or take shims out to
lower wings.
20. Re-install bolts and tighten to specs, see “ Torque
Values Chart ” on page 29.
Wing Adjustment (5317-5323)
Refer to Figure 11
21. The wings are to be leveled with the turnbuckle on
the wing cylinder mount .
22. Loosen jam nut and either shorten turnbuckle to
raise the wings or lengthen the turnbuckle to lower
the wings.
23. Re-tighten the jam nut to specs, see “ Torque
Values Chart ” on page 29.
Refer to Figure 12
24. Once machine is pre-leveled, raise and lower the
gangs completely to cycle and purge air from these
cylinders .
2
2
1
Figure 10
5313-5315 Wing Adjustment
42051
2
1
2
3
5
4
Figure 11
5317-5323 Wing Adjustment
42052
3
4
5
5
Figure 12
Gang Cylinder Purging
41983
6
6