GRE KWOV436, Инструкция по эксплуатации, Страница: 8 / 64

8
Previsions...
1 FILTER GROUP
The filter group and especially the electric pump should necessarily be located at a distance of at least 3.5 metres from the bowl
(electricity regulation NFC-100).
2 WATER EVACUATION:
Maintenance and wintering of the filter requires water evacuation.
The evacuation should be foreseen when installing the filter group.
3 FILTER TUBE:
In the case you want to bury the filter tubes, these should be protected against risk of deterioration, by protecting them with a
cover before burying them.
4 POOL ORIENTATION:
The pool should be positioned so the skimmer is facing the prevailing winds.
The skimmer is a very important element in the filter system and is always installed facing the prevailing winds. The optimum
filtering of the pool water depends on the suction capacity and position of the skimmer.
3
1
2
4
Figure 1
3,50 m minimum
The filter group should be located below the level of the pool and ideally at floor level of the pool, otherwise there is
a risk of the pump becoming deactivated. The filter pump should be protected from splashing of water, from floods,
and from humidity, in a dry, well ventilated place. Otherwise, the metallic pieces and the pump motor may become
deteriorated.
Installation
This is a determining stage in the construction of your pool. Certain works performed in situ, like the preparation of the land, the
concrete slab, the draining... can need the intervention of professionals that will propose the most adequate solutions.
Select the ideal location, in the sunniest spot possible, taking into account the local regulations (distance from the paths, public
rights of way, networks...) and the landscaping after installing the pool.
Decide the location by marking the ground, check the «Ground layout» section.
Your pool can be installed in these three ways:
Figure 2 Filter
level
Above
ground
Semi in-ground In-ground
If your area
is on a slope,
excavate till
it is level.
NEVER ADD SOIL TO
LEVEL IT