34
There are two possibilities to install the wall protecting blanket
TWO FACED ADHESIVE TAPE (NOT INCLUDED)
• Stick the two-faced adhesive tape panel by panel, aligning it with the upper part of the top boards (figure 27).
If the wood is slightly humid and dusty, it can be smoothened using sandpaper to facilitate adherence.
• Check that the walls and floor are clean.. Remove screws, bark, shavings, sawdust...
• Unroll the blanket aligning it to the upper edge of the top boards (figure 28).
• Cut of the excess blanket and eliminate any folds.
STAPLER (NOT INCLUDED)
• Staple the end of the blanket starting from a corner.
• Unroll the blanket aligning it to the upper edge of the top boards.
• Use one staple every 20 cm. (figure 29)
• Cut of the excess blanket and eliminate any folds.
Figure 27
Figure 28
Figure 29
The skimmer is the water suction point from the pool to the
filter. Its position facing the prevailing winds allows reco-
very of all the possible residues floating on the surface of
the water (dust, leaves...)
INSTALLATION
• Fix the first watertight seal (flat joint) to the body of the
skimmer using the 4 round-head screws, respecting the
illustrated position. Fixing of the skimmer joint.
Fijación de la primera junta
del skimmer
The refilling fitting with key is for introducing water into
the pool. It goes through the wall through the hole made
in the pre-cut board.
INSTALLATION
• Locate the position of the hole for the nozzle..
• Male a cross-shaped cut in the blanket from inside the
pool.
• Cut the blanket with a cutter.. The cut will be larger
than the hole (hole 2 cm).
Wooden
structure
Blanket
Figure 30
Protective wall blanket
Fixing of the skimmer joint
Location of the refilling fitting
The automatic cleaner connection
of the skimmer is only used for pool
maintenance.
Содержание KWOV436
Страница 2: ......