GRASS VALLEY UCP-3901, Руководство пользователя

Страница: 49 / 210

49
UCP - 3901
User Manual
Parameter Description
SDI IO Displays how input and output spigots are currently configured. See
Card Firmware/Software Version , below, for information on how to
change this.
Where Am I Causes the front-edge and rear panel LEDs to flash, allowing the card
to be easily identified.
Genlock Select Genlock type:
• Network - use the network’s PTP clock. See Time Sync
Configuration on page 50 for further configuration settings.
• External Reference - use the reference signal found at the REF
connector on the card’s rear panel. See Rear Panel and
Connectors on page 24.
• Freerun - card is using its own clock with no reference to any
other source.
GUID Displays the absolute unique identifier associated with the card.
Domain R uses domains to partition a network; only nodes on the
same domain can communicate with one another. A domain is
uniquely identified with a number and a friendly name/alias.
Set an ID as required, then press
Take to confirm the change.
Interface
Configuration
Displays the IP address for each of the Ethernet interfaces.
Card Firmware /
Software Version
Each software version contains multiple firmware images. These allow
different spigot input/output and flow standard combinations to be
selected.
Select the required software from the
Software Version pane, then
select the firmware which provides the required combination of
inputs, outputs and flow standards from the list displayed on the
Firmware pane. Note : Restore and Restart buttons are displayed only
when an item not currently installed is selected.
Click
Take to restart the card and implement any changes made.
See Upgrading the UCP - 3901’s SDC Application on page 183 for how
to change the SDC application.
Installed 25G /
50G Licensed
Options
Shows the currently installed licensed card options. See See Installing
a License into an UCP - 3901
on page 188 for how to install a license.