GRASS VALLEY KARRERA K-FRAME, Инструкция по установке и обслуживанию, Страница: 175 / 278

KARRERA K-FRAME — Installation & Service Manual 175
Multiple Suite Resource Sharing
GPI inputs themselves are not assigned to individual suites. Each suite can
be configured to respond to particular GPI commands, with the other suite
ignoring these commands.
Setting Up Resource Sharing
Preparation
Your Karrera K-Frame system should first be fully operational. For new
customers, an initial system configuration will be required. This basic setup
will become the baseline for suite 1 operation. This includes having an Eng
Setup configured with the sources defined, suite 1 outputs assigned, suite
1 tally contacts connected and Ethernet tally defined (if used), and any
external interfaces (DDR, VTR.) that will be used in suite 1 should be
installed and operational.
Default Suite Prefs should also be defined and saved under a file name
identifying its use for suite 1. A default Panel Prefs file should also be
defined and saved identifying it as a default setting for control surface A of
suite 1. All these files will become the starting point from which changes
will be made to make full use of Resource Sharing.
When the above is accomplished and basic system functionality is con-
firmed, you can then set up suite 2, and more easily troubleshoot any con-
figuration issues that may arise.
If you will be adding new system components for use with Resource
Sharing, all these components must be installed and configured on the net-
work, using valid IP addresses. All control surfaces participating in
Resource Sharing will also need to be in communication with the same
Video Processor Frame. After the primary Main panel has been installed
and its connectivity verified, one new panel should be installed and its con-
nectivity also verified before you install any additional panels. This will
make it easier to troubleshoot any IP addressing problems that may occur.
Prepare Worksheet
A worksheet is helpful for planning your multi-suite installation and con-
figuration. The worksheet should list all Control Panels, Menu Panels, and
PCs running the GV Switcher menu application, their IP addresses, and
their suite and control surface associations. It should also list all Remote
Aux Panels and which suite they belong to. Physical outputs should also be
listed with their suite association and which Fixed output or Aux bus they
are associated with, the main program and preview outs for the suite, etc.