GRAPHTEC CSX500 SERIES, Руководство пользователя

Страница: 46 / 84

2-26
• If the [Connect] button is displayed in gray, the scanner is being used with another
computer. Please connect the scanner when the [Connect] button display returns to
black indication.
• When the scanner is connected to the computer and no commands are received, it will
be disconnected after approximately 10 minutes.
Caution
• If the scanner is disconnected with the Scan window left open, the scanner will remain
in the scanning status, and cannot be used other computers. In this case, the scanner
must be turned off and then on again.
• The scanner’s network interface sleeps when the scanner is in energy-saving mode.
When connecting the scanner, bring it out of the energy-saving mode.
How to initialize the settings
The following methods will allow you to initialize the network environment for the scanner.
• Initialize with the scanner
• Initialize with the Network Utility
Once initialized, the IP address will become (0.0.0.0).
After initialization, insert the "IMAGE SCANNER USER GUIDE CD-ROM", which came with the
scanner, into the CD-ROM drive.
Go to “Install the Network Utility” and use “Setup” to execute the “Device Setup”.
(Refer to the “Setup procedure” mentioned before.)
Initialize with the scanner
Initialize the scanner if you change the environment of the network to which the scanner is connected.
Network connector
POWER lamp LINK lamp
Reset button
(for network)
Remove the Network Cable, and turn the scanner OFF.
Turn the scanner ON while holding down the Reset Button. (the POWER lamp on the right will light up)
Keep holding down the Reset Button until the LINK lamp on the left lights up.
When the LINK lamp lights up, let go of the Reset Button.
Turn the main power on the scanner OFF (on the O side), and switch the power ON after at least 5
seconds (on the
I side).
This will initialize the network environment.
Initialize with the Network Utility
Initialize the settings when changing the Network environment for the scanner.
Checkpoint
Set the browser’s proxy server to off when performing the initialization settings.
(1) Launch Internet Explorer.