GRAPHTEC CE5000 SERIES, Руководство по обслуживанию

Страница: 72 / 146

CE5000-UM-251-9370 6-34
6 DISASSEMBLY AND REASSEMBLY
How to reinstall the main board (Old type)
(1) Reattach in the reverse order in which it was detached.
(2) Install the main board corresponding to each model when replaying to the new main board.
(3) If you have “BOOT START ERROR” when you replaced the main board, Install the firmware for new
main board (see Section 7.10).
(4) Perform any adjustments required (see Section 7.2).
How to reinstall the main board (New type)
(1) Set the dip switch 1 of main board for corresponded model as shown in table below.
Dip Switch 1 2 3 4 Model
SW1
1 2 3 4
ON
OFF
OFF OFF OFF OFF CE5000-40CRP (Craft ROBO Pro)
SW1
1 2 3 4
ON
OFF
ON OFF OFF OFF CE5000-60
SW1
1 2 3 4
ON
OFF
OFF ON OFF OFF CE5000-120
SW1
1 2 3 4
ON
OFF
ON ON OFF OFF CE5000-120AP
(2) Reattach in the reverse order in which it was detached.
(3) If you have “BOOT START ERROR” when you replaced the main board, Install the firmware for new
main board (see Section 7.10).
(4) If you have “NV-RAM ERROR” when you replaced the main board, perform the NV-RAM Clear for new
main board (see Section 7.4).
(5) Perform the NV-RAM Clear when the dip switch setting was changed.
(6) Perform any adjustments required (see Section 7.2).