Sensors
06/06
1 of 4
WALL PLATE 95806
The Wall Plate allows for installation of
an Indoor Sensor on to an electrical box.
The wall plate can be mounted vertical
or horizontal and is designed to allow
wiring to feed through in both positions.
Included with the wall plate are screws
for mounting to the electrical box.
UNIVERSAL SENSOR 91746
The Universal Sensor has a zinc
sleeve for fast response and a wide
operating range. This sensor can be
used in a multitude of applications.
The sensor is supplied with 1 m (40”)
of two conductor wire.
OUTDOOR SENSOR 91629
The Outdoor Sensor includes a 10 k
thermistor which provides an accurate
measurement of the outdoor temperature.
The sensor is protected by a white U.V.
resistant PVC plastic enclosure.
INDOOR SENSOR 94107
The Indoor Sensor includes a 10 k
thermistor which provides accurate
measurement of the indoor temperature.
The sensor can be mounted directly on
the wall or mounted to an electrical box
using the enclosed Wall Plate. The small
size makes this sensor visually appealing
and less noticeable on the wall.
Defi nitions
- Warning Symbol: Indicates presence of hazards which can cause severe personal injury, death or substantial
property damage if ignored.
The following defined terms and symbols are used throughout this manual to bring attention to the presence of hazards of various
risk levels, or to important information concerning the life of the product.
Installation - Outdoor Sensor 91629
STEP ONE
GETTING READY
Check the contents of this package. If any of the contents listed are missing or damaged, please contact your place of purchase
for assistance.
Type 91629 includes:
One Outdoor Sensor, One GEO 360 Sensors Data Brochure
Sensor with
bottom entry
wiring
Sensor with
rear entry
wiring
Sensor mounted
onto 50 x 100 mm
electrical box
STEP TWO
MOUNTING THE SENSOR
Note:
The temperature sensor (thermistor) is built into the enclosure.
•• Remove the screw and pull the front cover
off the sensor enclosure.
•• The sensor can either be mounted directly
onto a wall or a 50 x 100 mm (2” x 4”) electri-
cal box. When the sensor is wall mounted,
the wiring should enter through the back
or bottom of the enclosure. Do not mount
the sensor with the conduit knockout facing
upwards as rain could enter the enclosure
and damage the sensor.
•• In order to prevent heat transmitted through the wall from affecting the sensor reading, it may be necessary to install an
insulating barrier behind the enclosure.
•• The sensor should be mounted on a wall which best represents the heat load on the building (a northern wall for most build-
ings and a southern facing wall for buildings with large south facing glass areas). The sensor should not be exposed to heat
sources such as ventilation or window openings.
•• The sensor should be installed at an elevation above the ground that will prevent accidental damage or tampering.
