24
❐
Never
use the device with just one plate.
Two
plates must always been in place. If only one
plate is installed, the thermostat could malfunction as a result. The device could overheat and
short circuit resulting in damage to the device.
Helpful tips:
• Always let the device heat up before using it. During the pre-heating process, you
can arrange the foods you would like to prepare.
• If you suspect that food is “sticking” to the plates, add a drop of oil to the plates
before placing the food on them and distribute it with a pastry brush.
Sandwich plate
You can use these plates to prepare sandwiches with delicious toppings. Let your imagination
run wild when it comes to toppings: from ham and cheese or pizza sauce and mozzarella up to
and including fruit toppings – anything is possible. You can prepare two sandwiches at the same
time.
1. Insert the sandwich plates in the device as described in the chapter “Inserting and changing
the plates”.
2. Connect the device to a properly installed, easily accessible socket. The red power LED will
illuminate as soon as the device has been connected to a socket.
3. The device must pre-heat now. Always keep the device closed during this time. The pre-
heating process takes about 3–5 minutes and has ended when the green power LED
illuminates.
4. Prepare your sandwiches during the pre-heating process.
• Place a topping of your choice on the bottom half. Place the topping in the middle of
the slice of toast. Make sure not to add too much of the topping to the slice of toast
as the device will press the slices of toast together and cut them in half. Otherwise
the topping will leak down the sides of the sandwich.
• To
enhance
the
fl
avour, coat the outside of the slices of toast with a small amount
of butter or margarine. Sandwich toasts can of course also be prepared without
butter – whatever you prefer.
• If you are preparing “sweet” sandwiches, e. g. with fruit toppings, you can coat the
outside of the toast slices with sugar for an extra crispy result.
5. When the green power LED illuminates and the pre-heating process has ended, release the
latch and open the device.
6. Insert the topped slice of toast in the bottom half of the device with the side coated with
butter or margarine facing down and place the second slice of toast so that it covers (with
the side coated with butter or margarine facing up) the
fi
rst slice of toast.
7. Close the device and lock it with the latch so that it stays closed during the baking process.
Please note that the green power LED may alternately turn off and back on during the baking
process. If the green power LED illuminates, this indicates that the device is reheating to
maintain a constant temperature.
8. After approx. 2–3 minutes open the device to check whether the sandwich has already been
toasted to perfection or whether it needs to be toasted longer.
