23
Inserting and changing the plates
ATTENTION!
❐
Make sure that the device is not connected to a socket when inserting or changing the plates.
❐
Make sure that the device and the plates have cooled off completely before you take the
plates out of the device or exchange them with another pair of plates.
1. Select a pair of plates you would like to insert in the device, open the latch and open the
device.
2. To insert a plate in the device, place the long catches of the
plate under the corresponding holders in the device (see
fi
gure). It is not important whether you insert the bottom or
upper plate
fi
rst.
3. Then push the plate on the “open” side into the device by
applying slight pressure until the short catches on the plate
audibly lock into place (see
fi
gure).
4. A latch (see
fi
gure) is located on the bottom and on the top
part of the device. If you would like to take the plates out of the
device or change them, you must push the corresponding latch
towards the handle; the plate will be ejected out of the device
and can be removed.
Use
ATTENTION!
❐
Hot surfaces!
Only hold the device by the plastic handles during operation and shortly after
turning it off. We recommend you wear kitchen gloves when handling the device.
❐
Scalding hazard!
Steam may be emitted from the device. Be careful when opening or
closing the device.
❐
Make sure that you do not over
fi
ll the device! The device should generally be easy to close.
Do not forcefully attempt to close the device!
❐
Be careful when
fi
lling the device with liquid waf
fl
e batter! If your over
fi
ll the device, the
batter may run over the sides of the device.