Golden Eagle MONROE, Руководство по эксплуатации и установке

Страница: 13 / 36

VERTICALLY WITH NEW CHIMNEY SYSTEM
(Refer to Figure 7)
OPTION: To achieve a center vertical
installation a 45º elbow and a clean ‐ out tee
can be used to offset the pipe from the
exhaust outlet to the rear center of the
stove.
OPTION: Install L ‐ Vent elbow in place of
clean ‐ out tee. Locate stove. Drop plumb
bob to center of tee outlet, mark point on
ceiling. Install ceiling support and L ‐ Vent
pipe per L ‐ Vent manufacturer’s
instructions.
1. Always maintain 3” clearance from
combustible materials. When passing
through additional floors or ceilings,
always install firestop spacer.
2. After lining up for hole in roof, cut either a
round or square hole in roof, always 3” larger all the way around pipe. Install upper edge and
sides of flashing under roofing materials, nail to the roof along upper edge. Do not nail lower
edge. Seal nail heads with non ‐ hardening waterproof mastic.
3. Apply non ‐ hardening, waterproof mastic where the storm collar will meet the vent and flashing.
Slide storm collar down until it sits on the flashing. Seal and install cap. Mobile home installations
must use a spark arrester.
VERTICALLY INTO EXISTING CHIMNEY SYSTEM
If you have and existing chimney system you can run your new
L ‐ Vent pipe up through the center of your existing chimney
system. (refer to figure 8)
Follow guidelines for equivalent vent length.
FOLLOW YOUR VENT PIPE MANUFACTURERS
INSTRUCTIONS REGARDING ALL ASPECTS OF VENT
INSTALLATION AND CLEARANCES.
Figure 7
Figure 8