GME Electrophone TX3400, Инструкция по эксплуатации

Страница: 9 / 25

9
Naming your Selcall Idents.
The TX3400 allows you to name up to four of
your most often used Selcall Idents using a 5
character word. The name can then be stored
in memory with the Ident. This makes it easier
to identify who’s Ident you are recalling from
the memory. In addition, if an incoming Selcall
matches one of the Idents stored in the
memory, its name can be displayed to make it
easier for you to identify the caller.
The QUIET Mode (Q)
Your TX3400 can be set to listen on a busy
channel but not allow any sound to reach the
speaker UNLESS it receives its own Selcall
Ident. In this way, your radio can monitor a
busy channel without disturbing you, but still
let you know when you are being called.
• The QUIET mode overrides the normal
Squelch system to ensure that the radio
remains quiet even when the channel is
busy or the Squelch is ‘opened’ with the
Squelch key. When QUIET is set, you may
see ‘BUSY’ appear on the display and
signal strengths appear on the ‘S’ meter
indicating the channel is being used.
However, unless someone transmits your
Selcall Ident, nothing will be heard in the
speaker.
• The QUIET mode can be set to work on
specific channels i.e. some channels can be
set to remain Quiet while others can remain
Open to all incoming signals.
If a signal containing your Selcall Ident is
received, the QUIET mode is deactivated and
an alarm sounds to alert you to the call. You
can then converse normally on the channel.
NOTE: Setting the QUIET mode is not
mandatory. You can still use Selcall on any
channel whether the QUIET mode is set or not.
SENDING SELCALLS
Use the following procedure to enter and send
Selcalls.
To enter a Selcall IDENT.
Briefly press the CALL button on top of the
microphone. ‘CALL TO’ will appear on the
display along with the last Selcall Ident you
sent.
You can now either send the Ident that is
presently displayed or enter a new Selcall
Ident. If you do nothing, the radio will
automatically exit the ‘CALL TO’ mode after 20
seconds and return to normal operation.
To enter a new Selcall Ident:
The righthand digit of the Selcall Ident will be
flashing. This flashing digit indicates the digit to
be changed
1. Rotate the Channel knob to select the
required number in the flashing digit
position.
2. Briefly press the Channel knob to select the
next digit to program. A high beep will be
heard and the next digit will flash.
3. Repeat steps 1 and 2 to program all 5 digits
as required.
Once the Ident has been entered you have 20
seconds to send it otherwise the ‘CALL TO’
mode will be cancelled and the Ident you
entered will be lost.
To Send the Selcall Ident.
With the required Selcall Ident displayed in the
‘CALL TO’ mode, press and hold the CALL
button for a few seconds until the radio beeps.
The Selcall Ident will be sent automatically and
the radio will return to normal operation.
Call Acknowledge.
If your Selcall transmission is successful, the
radio you called should respond with a ‘call
acknowledge’ signal - usually two quick beeps.
This will confirm to you that the radio you
called is now alerting its user to your signal.