GME Electrophone TX3400, Инструкция по эксплуатации

Страница: 18 / 25

The TX3400 has a number of features that can
be disabled individually by the user to allow for
much simpler operation. These include the
Priority, Scan, Duplex and Squelch/CTCSS
functions that are normally accessed via keys
on the front of the radio.
To disable one of the keys:
1. Tur n the radio OFF using the volume
control.
2. Press and hold the key you wish to disable
while turning the radio back on.
A low beep will be heard and the selected key
will no longer function.
To re-enable the key, repeat the steps above.
When the radio is turned on again, a high beep
will be heard and the key will function normally
again.
For example, to disable the SCAN function:
1. Tur n the radio OFF using the volume
control.
2. Press and hold the SCAN key while turning
the radio back on. A low beep will be heard
and the SCAN function will no longer be
available.
Repeat the procedure to re-enable the SCAN
function.
The TX3400 main unit is supplied with a slim,
slide-on mounting cradle. The cradle can be
screwed or bolted in any convenient location in
your vehicle (under or above the dash, on the
centre console, under the seat, in the boot, etc)
using the mounting slots provided in the base.
The main unit contains a built-in speaker, and
can be installed in a convenient location in the
vehicle’s cabin as the radio’s loud speaker.
Alternatively it can be installed “out of the way”
and an extension speaker used instead.
The remote head comes complete with a slim
mounting bracket and gimbal knobs. Its small
size and light weight allows it to be mounted in
almost any convenient position accessible to
the driver. If necessary, a 3 meter extension
cable (LE001) is available to extend the
distance between the remote head and the
main unit. For reliable operation, the total cable
length should not exceed 10 meters.
NOTE: If your installation does not require the
use of a remotely mounted control head, you
can convert your TX3400 to a compact
underdash radio by fitting the remote head
front panel directly to the main unit as
described later.
When installing the radio, avoid mounting it
close to heaters or air conditioners. Screw the
mounting cradle and the remote head bracket
to firm surfaces. Slide the TX3400 main unit
into the cradle from the front until it clicks into
place. Position the remote head in its mounting
bracket, adjust it for the correct viewing angle
and tighten the gimbal knobs securely. Finally,
plug the remote head into the front panel of the
TX3400 and the power and antenna leads to
the sockets provided on the rear of the radio.
Fitting Remote Head Bracket.
18
DISABLING FUNCTIONS
INSTALLATION