GME Electrophone TX3400, Инструкция по эксплуатации

Страница: 19 / 25

Fitting the Microphone.
The microphone uses a miniature 6 pin
telephone style plug and socket. To fit the
microphone:
1. Position the microphone plug so the plastic
tab faces downwards. Press the plug into
the socket until it "clicks".
2. Gently press the rubber strain relief into the
hole surrounding the socket so that the slot
around the strain relief fits neatly inside the
lip of the hole.
Removing the microphone.
1. Squeeze the rubber strain relief near the
front panel to disengage the slot, and slide
the strain relief back along the microphone
cord.
2. Squeeze the plastic tab on the microphone
plug towards the plug to unlock it while
gently pulling the plug outwards. If the plug
does not come out easily, the tab has not
released correctly and should be squeezed
again.
Converting the TX3400 into an Underdash
radio.
If your installation does not require the use of a
remotely mounted control head, you can
convert your TX3400 to a compact underdash
radio by fitting the remote head front panel
directly to the main unit as follows.
Remote Head Unit Disassembly.
1. Remove the two black screws from the
metal cable-clamp plate at the rear of the
remote unit.
2. Remove the 4 screws from the remote unit’s
rear case and remove the case.
3. Slide the rear case down the connecting
cable and carefully unplug the cable from
the PCB.
Main Unit Disassembly.
1. Remove the top and bottom covers from
the main unit.
19
Slide radio
from cradle
Plastic tab
Gently
spread
tabs
Gently
spread
tabs
Mounting the Cradle.
Fitting the Radio.
Slide radio fully into
cradle until it clicks
into place.
Removing the Radio.