GME Electrophone TX3400, Инструкция по эксплуатации

Страница: 14 / 25

14
PAGE MODE
Programming and Sending Group Calls.
Entering a Group call Ident is the same as
entering a normal Selcall Ident.
1. Briefly press the CALL button on top of the
microphone. ‘CALL TO’ will appear on the
display along with the last Selcall Ident you
sent.
The righthand digit of the Selcall Ident will
be flashing. This flashing digit indicates the
digit to be programmed.
2. Rotate the Channel knob to select ‘A’ in the
righthand flashing digit position. This is
special code that will create the Group Call.
3. Briefly press the Channel knob to select the
next digit to program. A high beep will be
heard and the next digit will flash.
4. Rotate the Channel knob to select the
required number in the next flashing digit
position.
5. Repeat steps 3 and 4 to program all 5 digits
as required. When completed, the first 4
digits of the Ident you have entered will
match all the radios in the group. The last
digit will be set to ‘A’.
Once the Ident has been entered you have 20
seconds to send it otherwise the ‘CALL TO’
mode will be cancelled and the Ident you
entered will be lost.
To Send the Selcall Ident.
With the required Selcall Ident displayed in the
‘CALL TO’ mode, press and hold the CALL
button for a few seconds until the radio beeps.
The Selcall Ident will be sent automatically and
the radio will return to normal operation.
Call Acknowledge in Group Mode.
There is no call acknowledge when sending
group calls. This is to prevent all the radios in
your group from trying to respond to your
Selcall transmission at the same time.
Storing group Call Idents.
Group Call Idents can be stored in memory in
the same was as a standard Selcall Ident.
Simply follow the instructions for storing Selcall
Idents in memory as described earlier in this
manual.
Receiving Group Calls.
Receiving a Group call is identical to receiving
a normal Selcall except that the alarm sound is
a LOW tone beep instead of the normal High
tone beep. The Callers Ident or Name appears
on the display in the usual way.
The PAGE or transpond feature allows you to
leave your radio unattended yet still be
informed of any incoming Selcalls. If your
Selcall Ident is received while your TX3400 is in
the PAGE mode, it will automatically call
another UHF radio to alert you to the call.
To receive the Paging call, the other UHF radio
must be fitted with a CCIR compatible Selcall
(such as a TX3400, TX4200, TX4000, TX6000
or TX475S.
NOTE: To allow your TX3400 to operate in the
PAGE mode when your vehicle is unattended,
your radio must be wired so that it has a
continuous 13.8 volt power source even when
the vehicles ignition is switched of f (see
installation instructions).
Selecting the Paging Channel.
Your TX3400’s Paging channel is factory set to
UHF CB channel 23. If channel 23 is not
suitable for use in your area, you can arrange
for your dealer to reprogram it to another of the
40 UHF CB channels.