GME Electrophone TX3400, Инструкция по эксплуатации

Страница: 10 / 25

10
STORING SELCALL IDENTS
Your TX3400 is fitted with four Selcall Ident
memories, allowing you to store up to four
frequently used Selcall Idents. The memories
are accessed using the four keys beneath the
display labelled 1, 2, 3 and P.
NOTE: The P key is normally used to store the
PAGE Ident for when the radio is used in the
PAGE mode, but it can be also be used as a
standard Selcall Ident memory if the PAGE
mode is not in use. (The PAGE mode operation
is described later in this manual).
To Store a Selcall Ident in memory.
1. Press the CALL button to select the ‘CALL
TO’ mode.
2. Enter the required Selcall ident as described
previously.
3. Now press and hold (for about 2 seconds)
one of the four keys directly below the
display labelled 1, 2, 3 or P. The Selcall
Ident will flash for a few seconds, then the
radio will beep as the Ident is stored.
To Recall a Selcall Ident from memory.
1. Briefly press the CALL button to select the
‘CALL TO’ mode.
2. Briefly press the appropriate memory key (1,
2, 3 or P). The Selcall ident stored in that
memory will be displayed.
3. Press and hold the CALL button to send the
Ident.
NAMING YOUR SELCALL IDENTS
Your TX3400 allows you to enter a 5 character
name for each Selcall Ident you have stored in
memory. This makes it easier to remember
whose Selcall Ident you are recalling. In
addition, if an incoming Selcall matches one of
those in your radio’s memory, the name can be
displayed instead of the Selcall Ident, making it
easier to identify the caller.
Switching between Ident Mode and Name
Mode.
The TX3400 can be toggled between the
normal Ident mode and the Name mode as
follows:
1. Briefly press the CALL button to select the
‘CALL TO’ mode.
2. Press and hold the Volume knob until the
radio beeps. The TX3400 will toggle
between the Ident mode and the Name
mode.
3. Briefly press the CALL button again to
return to normal operation. The radio will
remain in the selected mode.
Entering and Storing a Selcall Name.
NOTE: Before adding a Name to a Selcall Ident,
you should first store the required Ident in
memor y as described above. The steps
described below assume that your TX3400 is in
the normal Ident mode.
1. Briefly press the CALL button to select the
‘CALL TO’ mode.
2. Briefly press a memory key (1, 2, 3 or P). If
the radio is in Ident mode, the Selcall Ident
stored in that memory will be recalled and
displayed.
3. Press and hold the Volume knob until a
beep is heard. The radio will switch to the
Name mode and the displayed Ident
number will be replaced with characters.
4. Using the same procedure as used for
entering Idents, rotate the Channel knob to
select the required letter in the flashing
character position, then press the knob to
move to the next character position.
5. When all characters have been entered,
press and hold the memory key associated
with that Ident to store the Name. The radio
will beep and the Name will be stored.
Repeat the procedure to add Names to any
other Selcall Idents stored in memory.