GLT Fox-Up, Инструкция по установке и эксплуатации

Страница: 4 / 108

R
2
1. GENERAL NOTES
Fox up ventilation units are built in accordance with the latest technological standards and acknowledged safety regulations.
Installation and maintenance on the ventilation unit should only be carried out by specially trained personal in accordance
with the regulations on occupational safety and accident prevention.
The electrical connection must be carried out according the applicable national regulation. During installation
and maintenance work, all poles must be disconnected from the mains with a contact gap of at least 3 mm.
Disconnections must be fixed in the open position!!
The unit may only be used for its intended purpose. Improper use, installation or maintenance work carried out incorrectly and structural
modifications may affect the function and safety of the ventilation unit. In this case the warranty claims will not be valid.
Read these instructions carefully before beginning any installation or maintenance work and follow the advice given on installation and
maintenance.
Before installing the unit, check that the delivery is complete and intact, and contact us, at the address below, if any parts are missing or
damaged.
Intended use
Fox up ventilation units with heat recovery are designed for controlled room ventilation. The units should only be used to deliver air. The de-
livery of aggressive, flammable or dust-containing media is not permitted. Never operate the unit without the filter in place. The connection
of ventilation pipes from other ventilation systems is not permitted.
Fox up ventilation units are not suitable for construction drying, and should only be used once construction work has been finished.
Operating the unit in conjunction with heat-producing appliances may require additional safety devices. Relevant information is available
from a regionally qualified chimney sweep.
Placing the unit
Fox up ventilation units may only be installed and operated indoors. When selecting a site, please make sure that the unit is accessible for
service and maintenance. The unit must not be installed close to flammable liquids or gases. A mains supply (230 V/50 Hz) is required to
operate the unit.
Installation
When installing the unit, please observe the recognized codes of practice with regard to unit installation, electrical work, fire protection,
etc., as well as the standards for the ventilation of residential buildings.