“NEO” TV SATELLITE ANTENNAS
105
www.glomex.it
ENGLISH
12. UPDATING THE BOARD ANTENNA USING THE SD CARD
If board antenna software cannot be updated via
App. (paragraph ) the SD Card must be used to
do so.
The SD card must be inserted into the relevant
slot on the control unit side.
The SD card used for updating must be
formatted in FAT32. The ABOARD.HEX file
provided must then be copied on the SD card;
proceed as follows:
1. Turn off the decoder, the TV set and make sure
that the switch on the control unit is set to OFF.
2. In case of built-in installation: remove the wall-
mounting plate (see
Fig. 33
), loosen the screws
and remove the built-in control unit.
3. Insert the SD card in the slot on the side of the
control unit, as shown in
Fig. 54
. Turn the control
unit on (button B,
Fig. 39
) until the control unit
LED blinks for a few seconds and then turns
orange. When the update is completed, the LED
becomes green. If the LED blinks red/green, the
update was not successful. The updating
procedure must be performed again from the
beginning.
4. After completing the updating procedure, turn
off the control unit, remove the SD card and
reinstall the rear cover onto the control unit.
5. In case of built-in installation: insert the control
unit into the wall, reinstall the fastening screws
and the installation plate.
S
WARNING
In case of repeated failures in the software
update procedure, please contact the GLOMEX
Service Centre.
NOTA:
it is possible to download the necessary
software updating file from the Glomex website
(www.glomexmobile.com) in section “Technical
Support - Download Area”.