“NEO” TV SATELLITE ANTENNAS
93
www.glomex.it
ENGLISH
If the connection between the App and control
unit is successful, the status LED on the control
unit becomes red, whereas the App control
panel is like shown in
Fig. 42
(the connection
status will be green).
After the first connection, if the Control Unit is not
reset, each time you will open the App, this will
automatically try to reconnect to the Control
Unit.
When the App is connected to the Control Unit
“SAT 1”, “SAT 2” and “SAT 3”, above the selector,
will be replaced by the satellite names.
If the connection between the App and control
unit is not successful, the control unit status LED
continues blinking with the green light, whereas
the App control panel is like shown in
Fig. 43
(the
connection status is red) and the message
“Control unit not connected” will appear for a few
seconds.
This problem may occur for two reasons:
1) the mobile devices is too far from the control
unit. Move closer to the control unit and repeat
the procedure to connect to the antenna’s
Bluetooth signal.
2) the mobile device being used for connecting is
not the last one to have connected to the control
unit. Repeat the coupling procedure described in
paragraphs 8.1 and 8.2.
Fig. 42
Fig. 43
