“NEO” TV SATELLITE ANTENNAS
99
www.glomex.it
ENGLISH
In case of problems during the update
procedure, an error message appears on your
smartphone/tablet and the control unit LED
becomes red. In this case, the control unit must
be reset as indicated in paragraph 8.1.
If the board antenna software cannot be updated
via App, use the SD Card, please refer to
paragraph 12.
9.4 SETTING THE PARAMETERS OF A
SATELLITE MANUALLY
The parameters set for each satellite can be
changed in the advanced mode:
Orbital position
Frequency
Polarization
Symbol rate
FEC
NID
Mesh mode
To manually change every single parameter you
must click on the highlighted button (
Fig. 50
).
Then a warning disclaimer is shown (
Fig. 51
),
press OK to proceed.
Now the parameters can be changed (
Fig. 52
)
and tested/saved in the three SAT positions of
the control unit.
If the “Test” option is selected, the modified
parameters are cancelled when the control unit
is turned off.
If the “Save” option is selected, the modified
parameters are saved in one of the three SAT
positions as you wish.
Fig. 49A
Fig. 50
