Gilras GRU-5000 A, Руководство по эксплуатации

Страница: 16 / 68

Chapter 3 Installation
- 7 -
3.3.5. Connection of Foot Switch
Plug the Foot Switch connector into the Foot Switch Socket on the rear panel of the instrument, as
show in Figure 3.5.
3.3.6. Replacement of Printing Paper
The built-in printer is a thermal printer that uses thermal printing paper. Please purchase and
replace the printing paper according to the specific model provided by the Manufacturer, see
§8.2.1 Consumables.
Replacement of printing paper:
1) Press "OPEN" button to open the cover of the paper housing;
2) Take out the reel of the paper from the paper holder and add new paper, see Figure 3.6;
Figure 3.6 Replacement of Printing Paper
3) Pull out the printing paper from the paper slot for about 1cm, and push lightly to close the
cover of the paper housing. Pay attention not to let the paper stuck in the slot. Close the paper
housing finally.
Note: 1) If the paper doesn't run properly, please check installing method and
reinstall.
2) The thermal paper has thermal side, when the paper runs normally but
nothing printed out, please open the paper housing and reinstall the
printing paper with the other side.