GILES OVH-10-C, Руководство по эксплуатации и обслуживанию

Страница: 41 / 54

31
Model: OVH-10-C Hood Cleaning & Maintenance
This Section describes the steps to generally maintain and clean the OVH-10-C Hood. Attention to these
procedures will help ensure the hood remains in good operating condition and continues to run efficiently
and safely.
A Maintenance & Service Log is provided in this manual, see Table 5.03.
The Hood design incorporates various interlock devices to ensure that the unit will shutdown in the event that
certain conditions exist that are not consistent with safe and effective operation. These interlocks should be
tested MONTHLY as described below. Use the
Maintenance & Service Log and place a check in the box
that corresponds to each functional test. If a problem is found, contact a service provider.
1.
Door Interlock Check:
Turn power switch
ON.
With Hood running, unlatch and slightly open the
Filter Access door. Confirm Hood powers off when door is opened. Check the under-hood
appliance to ensure that it cannot be turned on.
2. Baffle Filter Check: Place power switch in the OFF position, open Access Door and remove the
Baffle Filter. Close door and turn power
ON
. The red
Baffle or Charcoal Filter Missing
light
should illuminate and the Appliance Powered light should be OFF . Check the under-hood
appliance to ensure that it cannot be turned on. Turn power OFF and reinstall the Baffle Filter.
3. EAC Filter Check: Place power switch in the OFF position, open Access Door and remove the EAC
Filter. Close door and turn power
ON
. All three EAC status LED’s should illuminate and after
approximately 2 minutes, an intermittent tone (beeping) alarm should sound. The Appliance
Powered light should turn OFF. Check the under-hood appliance to ensure that it cannot be turned
on. Turn power switch OFF and reinstall EAC Filter.
4.
Charcoal Filter Check:
Place power switch in the
OFF
position, open Access Door and remove the
Charcoal Filter. Close door and turn power ON . The red Baffle or Charcoal Filter Missing light
should illuminate and the Appliance Powered light should be OFF . Check the under-hood
appliance to ensure that it cannot be turned on. Turn power OFF and reinstall the Charcoal Filter.
5.
Filter Clogged Check:
Perform this check ONLY after installing a new Charcoal Filter. The easiest
method for checking the clogged filter interlock is to completely cover the hood’s exhaust outlet
with piece of cardboard while the hood is running and the appliance power is
ON. A continuous
tone alarm should sound as the exhaust is covered, the red Baffle or Charcoal Filter Clogged light
should illuminate and the Appliance Powered light should turn OFF. The appliance should also turn
OFF
during this time. Remove the obstruction; the alarm should silence and power should be
restored to the appliance. If the alarm tone does not sound, fails to silence, or the appliance fails to
turn
OFF or turn ON , contact a service agent to have the Clogged Filter interlock checked.
5. Hood Cleaning & Maintenance
5-01. Monthly Interlock Check