GIGA-BYTE TECHNOLOGY GA-Z270X-UD5, Руководство пользователя, Страница: 82 / 136

Configuring a RAID Set - 82 -
B. Rebuilding an Array
Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies only
to fault-tolerant arrays such as RAID 1, RAID 5 or RAID 10 arrays. The procedures below assume a new drive
is added to replace a failed drive to rebuild a RAID 1 array. (Note: The new drive must have equal or greater
capacity than the old one.)
Turn off your computer and replace the failed hard drive with a new one. Restart your computer.
•
Performing the Rebuild in the Operating System
While in the operating system, make sure the chipset driver has been installed from the motherboard driver
disk. Then launch the Intel
®
Rapid Storage Technology utility from the Start menu.
Step 1:
Go to the Manage menu and click Rebuild to
another disk in Manage Volume .
The Status item on the left of the screen displays
the rebuild progress. After the RAID 1 volume
rebuilding, the
Status will display as Normal .
Step 2:
Select a new drive to rebuild the RAID and click
Rebuild .