• Floor
NOTE
If you use protective booth paper or coating, replace it when it becomes worn or dirty.
• Doors/curtains
NOTE
Check to make sure the door opens and latches without difficulty.
2.
Visually inspect all other surfaces for accumulated buildup; remove overspray or clean as required.
Check operation of product doors
NOTE
Perform this task for each product and personnel door installed in the booth.
1.
Remove any overspray from the door or clean as required.
2.
Check that the door swings freely.
3.
Check that the latch holds the door in place.
4.
Check that the seal on the door is in good condition.
Check lights
Inspect the lights to look for individual lights that are dim or burned out, and to evaluate overall light quality:
• If a specific light bulb is burned out or is noticeably dimmer than the other bulbs: Follow the
instructions in “Replace a defective bulb” (page 36) to replace the affected bulb.
• If the overall light quality is diminished: Follow the instructions in “Replace the protective light
covering” (page 36) to replace the protective layer or clean the light.
Service and maintenance
Global Finishing Solutions
25
239-062 rev 5
