GENERAL DESCRIPTION
E
N
G
L
I
S
H
7
The thermostat can be set with 2 different control modes:
•
Slave:
operation depends on the device configured as the Master (e.g. the Easy flush-
mounting timed thermostat GW1x764H), which decides the type, operating mode or
setpoint of the thermostat. In the first case (mode), the thermostat uses the setpoints
set locally. The fixed temperature setpoint can be temporarily forced (max. variation
±3°C), but the operating mode cannot be altered. The forced setpoint will remain
valid until the master device sends a new operating mode. In the second case
(setpoint), the thermostat uses the setpoint received from the Master device (which
can always be altered locally with a max. variation of ±3°C.
•
Autonomous:
the thermostat type and operating mode can be set locally. Operation
is not dependent on any other device. In the autonomous control mode, you can alter
the setpoint as you wish, and enable the thermostat to receive remote mode-setting
commands (OFF/Economy/Pre-comfort/Comfort) and type-setting commands
(Heating/Cooling) from other devices such as a push-button or the GSM Easy remote
control.
The thermostat has 4 different operating modes:
• ECONOMY
• PRE-COMFORT
• COMFORT
• OFF - ANTIFREEZE/HIGH TEMPERATURE PROTECTION
In the autonomous control mode, to switch from one HVAC mode (economy, pre-comfort,
comfort, off) to another, use the
key: each time it is pressed, the corresponding
setpoint is shown (flashing) for a moment.
In the slave control mode, no local modification of the HVAC mode is allowed; only the
manual switch-off (if enabled) of the device is possible (HVAC OFF).
In the
economy, pre-comfort and comfort operating
modes
, the thermostat always uses the corresponding
temperature set-points.
The display shows the detected room temperature and the
,
or
symbol.
Control modes
Operating modes
