Common settings for all the control algorithms
Setting the control modes
Use the
or
button key to modify the operating mode
of the thermostat from Slave to autonomous and vice versa
(SLA = slave; AUT = autonomous). To confirm your choice
and move on to the next parameter, press the
button key
within 30 seconds.
Enabling remote commands
Use the
or
button key to enable the possibility to receive
remote commands when the device is set as autonomous
(ON = remote commands enabled; OFF = remote commands
disabled). This screen is visible if the device has been set as
“autonomous” on the previous screen.
To confirm your choice and move on to the next parameter,
press the
button key within 30 seconds.
By enabling the remote commands, you can set the
thermostat type and operating mode from a remote device
(e.g. the GSM Easy remote control). During normal
thermostat operation, when a remote command is received
the
symbol will flash as long as the active mode is the
one set via the remote device.
Thermostat switch-off deactivation
Use the
or
button key to set the condition that allows
you to deactivate the thermostat switch-off (LOC = locally;
ROL = remote and/or locally). This parameter is only visible
if the thermostat has been set as a Slave or as
“autonomous”, with Setpoint control. To confirm your
choice and move on to the next parameter, press the
button key within 30 seconds.
The setting of the thermostat parameters is now complete.
Press the
button key to return to normal operation.
USER INSTRUCTIONS
E
N
G
L
I
S
H
27
Setting the inertia for speed 3
Use the
or
button key to set the value of the inertia
time for fan coil speed 3 (the gap can be set from 0 to 10
seconds). To confirm your choice and move on to the next
parameter, press the
button key within 30 seconds.
