Gewa Control Omni, Руководство по настройке

Страница: 31 / 52

31
Setting the Alert function
The
“Alert” is used when you want to attract somebody’s attention. Your Control Omni can
activate the Alert in different ways:

Transmit an IR-signal which activates a relay in an IR receiver.

Transmit an RF-signal which activates a relay in a radio receiver.

Send an SMS with the built-in telephone.

Call a telephone number with the built-in telephone.

Activate the built-in relay output.
When selecting function an IR-signal, an RF-signal, a telephone number or SMS is also set.
Note! Several functions can be activated simultaneously.
The relay function is to be connected to the same input as the switch. If you need to connect
both a switch and a relay function, a Control Omni Y connector is needed. The Y connector
can be ordered separately (item no 429050).
Set the Alert function by using the following procedure:

System

Alert function 
Select way to alarm
Warning!
When using the
“Alert” function you must be aware of the fact that batteries may
run out, connected plugs may be disconnected unintentionally, you may struggle to
reach the switches, the telephone network is down etc. The Alert function must not
be used as emergency alarm and never be used if a person is in danger if the Alert
fails.
Using the Alert Function with a switch
If an external switch is pressed for 1-15 sec. the alert will be activated. The time is set from 1-
15 sec. or can be switched off completely. When activating the alert function a symbol will be
shown on the screen with a sound signal. To choose how the alert is to be activated see
previous section
Setting the Alert function on page 27.
Set time by using the following procedure:

System

Alert function

Switch time 
Select time
Default setting: Switched off