Gewa Control Omni, Руководство по настройке

Страница: 23 / 52

23
Creating Macros
Your Control Omni can send macros which means that it can emit IR-signals, radio signals
and activate a button with recorded sound. Your Control Omni automatically carries out a
sequence of operations after
one button is pressed. For example, 4 buttons must be
pressed in order to reach a page on your TV-menu. You can create a macro from these four
button presses. A macro can last for up to 11 seconds. When creating a Macro it is possible
to set the time between each button press. This is made by pressing the same button on
which the Macros can be stored
. When creating the Macro the time for each press is also
shown.
Note! The button that is selected for storing the macro is given a temporary image .
Tip! There is also possible to repeat a macro by selecting
Repeat Macro
. This could be
used when changing the TV channels, for example select one button ( P+) and then the
function will be repeated the number of selected repetitions or until next press on the control
switch.
Create an IR macro by using the following procedure:
 Pages/buttons  Select page 
Select a page on which the macro is to be
stored
 Select this page  Edit button 
Select the button on which the macro is to
be stored
 Function  Environment  Macro  Start macro recording 
Select the
buttons that are to be included in the macro
 Save
Adding radio control
In Control Omni it is possible to control different devices with Gewa Radio (GR).
GR unit can be a radio receiver (GR receiver) or a radio transmitter (GR transmitter) from
Abilia or a switch and wall outlet from Schnider (Connect) and Merten (System M).
Before entering GR units the following must be considered:

Appliances possible to control are switches and wall outlets from Schnider (Connect)
and Merten (System M).

We recommend you to start by resetting GR units (Delete GR units) before entering
them in Control Omni. If a GR unit has been programmed it cannot be added again
without a reset.

Control Omni must always be used as the primary transmitter. Start by progamming
Control Omni and then add other GR transmitters. To add other GR transmitters we
recommend you to read the GR manual.

When a Control Omni has been programmed with GR units a back-up should be made
to save all settings. It is always possible to use the backup-file for another Control
Omni and thus restore the same functions.

If Control Omni should be switched off or break other GR transmitters, programmed in
the system, will always continue to work. If Control Omni is replaced by another
Control Omni a back-up must be used from a broken unit.