Gerber HS750 Plus, Руководство пользователя

Страница: 89 / 94

HS750
plus
Reference Card
KEY/FUNCTION DESCRIPTION
RUN SINGLE Key --
Plot Press
RUN SINGLE
to plot single jobs. The HS750
plus
returns to the off-line
status (as at power-up) after each job and waits for the operator to press
RUN
SINGLE
key again to plot the next job.
Controlled Stop Press either Run key to pause plotting at the next logical break in the
program and check current job.
Slewing while in pause will result in the
plotter returning to the position in the job and resuming the job when
RUN
SINGLE
is pressed again.
RUN CONT Key --
Plot Press
RUN CONT
to plot two or more jobs continuously. The HS750
plus
plots
one job after the other without pausing between them and remains on-line
until the
RUN CONT
key is pressed again or
RESET
is pressed.
Controlled Stop Press either Run key to pause plotting at the next logical break in the
program and check current job.
Slewing while in pause will result in the
plotter returning to the position in the job and resuming the job when
RUN
CONT
is pressed again.
Slew Keys (Arrow
Keys)
The arrow and
SLOW
keys do not function while a job is plotting, during an
error condition, or while a Run light is on, even if the plotter is idle.
Press arrow keys to position carriage and material between jobs.
•
Up and down arrow keys move the carriage between the rear and the front
of the plotter.
•
Left and right arrow keys rotate the drum and feed material through the
plotter or back toward the roll holder.
SLOW Key Press the
SLOW
key (a single beep indicates slow slew mode) and press the
arrow keys to slow slew. Press the
SLOW
key again (two beeps indicate
normal slew mode) and hold down a right or left arrow key to ramp up to high
speed slew.
RESET Key --
Emergency Stop Press
RESET
key to stop HS750
plus
operation, clear the current job from the
buffer, and return the plotter to off-line status.
Clear Press the
RESET
key to stop the error signal after a power-up or plotting
failure. (See “Error Conditions” section in this manual.)
Access Hold the
RESET
key at power-up to access additional diagnostics. (See
“Special Diagnostics” section in this manual.)